What are the points for attention in the operation of the disc trenching machine?
Published:
2023-05-19
Disc trenching machine has a wide range of applications, we must need to know the operation points for attention before using it.
Only in this way can we use it better.
If you are interested in this topic, let's take a look at it. I hope it can be helpful to some people concerned.
Disc trenching machine is widely used in various industries, so its use must be very extensive.
In fact, this disc trenching machine checks the lubricating oil in the gearbox before use, so that the amount of oil immerses the gear in the end.
Add grease to the grease nozzle of the transmission mechanism every 3 hours.
Or after each operation is completed, the oil and dirt of each part should be cleared in time, and the control parts and joints should be checked for loosening.
Of course, the gearbox should be cleaned 20 hours after the first operation.
First, the waste gear oil is discharged from the oil outlet, the appropriate amount of kerosene is injected from the oil injection port, and the gear mechanism is turned at the same time.
After cleaning, remove kerosene and add gear oil to 1x4 of the gearbox.
The next thing to note is that the gear oil needs to be changed every 100 hours.
After a total of 1000 hours, the gears in the box should be inspected and the seriously damaged or worn parts should be replaced.
In addition, it should be noted that holding the driver's license of the agricultural disc trenching machine, and after special technical training, familiar with and master the structure and performance of the trench digger, operation, daily maintenance and other professional knowledge.
Shall not be specially trained to operate in case of accidents.
When the disc trenching machine is running, check carefully before working, whether the parts are loose, whether the blade is installed correctly, etc., do not use when the clutch of the trench digger is unreliable, so as to avoid accidents.
If the blade is installed upside down, it will not work properly.
When the disc trenching machine is driving on the road, the power of the tool should be cut off, and the tip of the tool is more than 15 cm from the ground. It is not suitable to drive too fast.
When turning the head of the field, first cut off the walking power, and then cut off the power of the trenching machine, raise the handframe to make the knife tip off the ground, and turn at a low speed.
It is also important that the studio use the target method to ensure that the ditch will not bend.
If there is a bend, it should be corrected slowly through the handframe, but not too hard, so as to avoid accident or machine damage.
Or when opening ditches, do not stand in the soil area, so as not to be hurt by gravel or tiles, try to choose dry soil operations, strictly forbidden to work in old cemeteries or old road ruins and other places.
Due to the limitation of the structure of the disc trenching machine, it can not be trenched near the field ridge.
It is appropriate to be 1 meter away from the field ridge, and the width should be selected according to the needs.
The content of the above article is about the operation precautions of the disc trenching machine for your friends, and a better disc trenching machine manufacturer is also shared in the content. If you have this need, you can check it out. I hope I can help you.
19 May,2023
Detalle +19 May,2023
Detalle +